User guide
Table Of Contents
- Introducing the IRISPen
- Installation
- Starting up
- Basic settings
- Frequent commands
- Learn how to...
- Customize/save/reopen settings
- Read dot matrix text
- Read small print
- Read numeric data
- Read handprinting
- Read barcodes
- Scan multiple lines
- Scan from right to left
- Scan negative images
- Scan vertical text (optional)
- Define the symbol for unknown characters
- Replace a character string
- Replace vertical lines
- Program hotkeys
- How to get product support?
- How to register?
IRISPen Executive 6 - User's guide
8
• Press the pen onto the paper and roll it over the text line at a
steady rate. Once pressed, the start switch is activated and the
data is illuminated by a green light.
Warning:
Make sure you hold the pen at the correct angle, otherwise the
data may not be scanned properly.
Correct position
Incorrect positions
• Once you have reached the end of the line, lift the IRISPen.
Make sure you lift it after the last character of the line.
! Do not scan a line longer than 12" (30.5 cm). The scanning
stops as soon as this line length is exceeded.
• Operate exactly the same way for the next line.
Also see: Learn how to... Scan multiple lines.
Tip:
Check the image you generate