User's Manual

9
INSTALLATION AND OPERATION
• Connect HDMI cable from the Transmitter’s pass-thru
output port to the input of the display device to enjoy
the video coming through HDMI1 only.
A) Connecting Source Components To The Transmitter
a. HDMI Media Source
• Note : It is recommended that HDMI1 input port be used if only one HDMI source
component is present.
• Connect HDMI cable from the source components
output to the Transmitter's HDMI1 or HDMI2 or
HDMI3 input port.
B) IR Flasher Installation (Setting Up IR Remote Control Capabilities for Source Devices)
IR-OUT Port
IR Flasher Eye
Before starting the installation, please ensure that all source components (Blu-ray player, cable
box, etc.) and the display equipment (TV, display, projector, etc.) are turned off.
For initial setup of your HD FLOW3 Super mini system complete steps A, B, C, D, E and F in
order.
IR Flashers are provided to allow for control of up to three source devices using the device’s
original remote control at the Receiver location.
1.
2.
Connect the provided IR Flasher to the IR-OUT port of the Transmitter.
Find the location of the IR window on your component and adhere the IR Flasher Eye directly
over the IR window of your component.
•
•
Note: One IR Flasher Eye is to be used for one component device.
Tips: Most often the IR window on the source device is easier to locate with direct light
shining on sections of the front panel of the device (a small flashlight or a camera phone
flashlight works well).