User's Manual

6
1
1
2
4
5
6
Transmitter Front
1. Power/Link Indicator Light
•
•
•
•
•
•
•
•
•
•
Blinking indicator light - Establishing link between the Transmitter and the Receiver.
Solid indicator light - Link between the Transmitter and Receiver
has been established and is ready for signal transmission.
The HDMI 1 indicator light will be illuminated when
the HDMI 1 port is selected for video input.
If there is no signal, and/or the cable is not connected,
the indicator light will blink.
The HDMI 2 indicator light will be illuminated when
the HDMI 2 port is selected for video input.
If there is no signal, and/or the cable is not connected,
the indicator light will blink.
The HDMI 3 indicator light will be illuminated when
the HDMI 3 port is selected for video input.
If there is no signal, and/or the cable is not connected,
the indicator light will blink.
•
IR receiving window enables remote control of
the transmitter and the receivers.
When powered on: Press for one second to select
the video input source.
Each press of the button will cycle through t
he available video input "HDMI1→HDMI2 →
HDMI3 → HDMI1" in sequence.
Press and hold for 8 seconds until all indicator
lights blink synchronously, you are now in Scan/Pairing Mode.
• Connects IR Flasher to the Transmitter for
remote control of external devices which
are connected to the Transmitter
(i.e. Blu-Ray player, DVD, STB, etc).
2. HDMI 1
3. HDMI 2
4. HDMI 3
5. IR Window
6. Link/Source Selection Button
3
2
Transmitter Back
1. HDMI 1 IN
• HDMI1 input port.
2. HDMI Pass-Thru
• Outputs a duplicate of the source that is plugged into.
3. HDMI 2 IN
• HDMI2 input port.
4. HDMI 3 IN
• HDMI3 input port.
5. IR-OUT
6. DC
• 12V DC power input.
3 4
5
6