User's Manual

COMPLIANCE STATEMENTS

FCC Compliance

CE Compliance

IC Compliance

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is

subject to the following two conditions: (1) this device may not cause interference, and (2) this

device must accept any interference, including interference that may cause undesired

operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil

ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d'en compromettre le

fonctionnement.

The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the

potential for harmful interference to co-channel mobile satellite systems Any changes or

modifications (including the antenna) made to this device that are not expressly approved by

the manufacturer may void the user’s authority to operate the equipment.

To comply with RF exposure compliance requirements, a separation distance of at least 20 cm

must be maintained between the antenna of this device and all persons. This device must not

be co-located or operation in conjunction with any other antenna or transmitter.

This class B digital apparatus complies with Canadian ICES-003.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference to radio communications.

However there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to:

This device has been tested and found to comply with the following European Union directives:

Electromagnetic Capability (89/336/EMC), Low Voltage (73/23/EEC) and R&TTED (1999/5/EC).

Relocate the receiving antenna.

Increase the separation between equipment and Receiver.

Connect the equipment into an outlet on a circuit different from that to which the Receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.