User's Manual
12
Factory Reset
CAUTION:
How To Check Firmware Version
Notes:
Supported Video Formats
Video
Standard
Resolution
HD FLOW3 Super mini Transmitter
"VESA
Format
(PC standard)"
640 x 480p60
640 x 480p70
640 x 480p85
800 x 600p60
800 x 600p70
800 x 600p85
1024 x 768p60
1024 x 768p70
1024 x 768p85
1152 x 864p60
1152 x 864p70
1152 x 864p85
1280 x 800p60
1280 x 960p60
1280 x 960p70
1280 x 960p85
1280 x 1024p60
1360 x 768p60
1440 x 900p60
1600 x 1200Rp601
1600 x 900p60
1680 x 1050p60
720 x 480I60(NTSC)
720 x 576I50(PAL)
720 x 480p60
720 x 576p50
1280 x 720p50
1280 x 720p60
1920 x 1080i50
1920 x 1080i60
1920 x 1080p24
1920 x 1080p25
1920 x 1080p30
1920 x 1080p50
1920 x 1080p60
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
HD FLOW3 Super mini Receiver
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
"DTV
Format
(TV standard)"
To complete a factory reset, complete each of the steps below for both the transmitter and
receiver. These do not need to be done at the same time.
systems (systems with two or more receivers) as the pairing will be forgot. One will have
to re-pair the additional receivers if a factory reset is completed.
1.
2.
3.
4.
Unplug the device from its power source.
Press and hold the Link/Source (Tx) or Link/Output (Rx) Selection button on the front panel.
Plug the DC power back into the unit being reset.
Continue holding the Link/Source (Tx) or Link/Output (Rx) Select button for about 6 seconds
until all lights blink at the same time then release.
Allow the system to re-start and show content.
1.
2.
Make sure the HD FLOW3 Super mini System is up and running.
Using the HD FLOW3 Super mini remote supplied, point it at the Receiver IR window. Press
the Info/OK button. In the list of information there will be stated “Firmware Version:”
1.
2.
1600 x 1200p60 is a reduced format.
HD FLOW3 Super mini simply relays the input format of the video from the Transmitter to the
Receiver.
HD FLOW3 Super mini does not change the video format. If you want to change the output
resolution, you should change the format on the external device which is connected to the
Transmitter.