User's Manual

Multicast Mode - Pairing Additional Receiver(s) With The Transmitter

(Optional)

Tips

Indicator Lights Decoded

Multicast Wireless Mode enables the Transmitter to stream AV media from one Transmitter to up

to six Receivers.

Note: Your HD FLOW3 Super mini Wireless AV Multi-Display System comes pre paired. This

section is only needed if you have separately purchased additional Receiver(s).

If the Transmitter and Receiver are not establishing a connection:

If you have purchased additional Receiver(s) use the following instructions to add the

Receiver(s) to the current system, or follow the steps in the HD FLOW3 Super mini Receiver

manual. The system can have receivers added at any time.

Each receiver will have to be paired with the transmitter one at a time. Do not begin pairing

another receiver until the previous receiver has rebooted after pairing as described in the steps

below. A maximum of 6 receivers may be paired to one transmitter.

Press and hold the “Link/Source” button on the transmitter for 8 seconds. The lights will blink

sequentially from top to bottom. The transmitter will remain in pairing mode for 2 minutes or

until it senses a receiver trying to link.

Press and hold the “Link/Output” button on the desired receiver for 8 seconds. The lights will

first blink sequentially from top to bottom; then in various patterns. After about 30 seconds the

receiver will successfully link with the transmitter and then shut off and reboot itself. The entire

process will take under 1 ½ minutes and video will not appear on the display until the process

is complete. Video on the additional paired receivers will be lost during this process.

Repeat steps 1 and 2 for each additional receiver, if any.

It is recommended to unplug the power to both units for 30 seconds and then plug them back in.

If the above tip does not assist, please reference the Factory Reset section of this manual.

If the connection has been established and the HD FLOW3 Super mini logo can be seen on the

display device, but content is not playing when initiated:

If the HD FLOW3 Super mini logo nor the video content are being displayed, verify that the output

selection on the Receiver and input selection of the display are correct. Also, make sure cables

are completely pressed into place and secure, and that the selected source content is playing.

Ensure that source cables are properly connected.

Ensure the Transmitter is set to the proper input port and that the Receiver is set to the proper

output port.

Ensure the source is operating.

The display device needs to be able to support the resolution of the media source that is being

streamed. Utilizing the INFO button, while connected via HDMI, will allow you to see the EDID

resolution data that the display device accepts.

(Example - If the display device supports the highest resolution of 720p but the source device is

outputting 1080p content, the content needs to be downscaled to the maximum resolution of the

display device, in this case 720p).