User manual
Table Of Contents
- Front page
- Warnings/Approvals
- Addresses
- Preface
- Table of Contents
- 1. Introduction to the ida 812-1x MIO
- 2. Installing the ida 812-1x MIO Interface
- 3. Installing the ida 812-1x MIO Printer
- 4. ida 812-1x MIO Operation
- 5. Front Panel Setup
- 6. Errors and Recovery
- 7. Function Selection via the Line
- 8. FSL Setup via PC's parallel port
- 9. Font Selection
- 10. Test Settings Printout
- List of Abbreviations
- APPENDIX A - FSL Functions
- Appendix B. DIP Switch Settings
- Index
- READER'S COMMENTS

ida 812-1x MIO Operator’s Guide
Table of Contents
-6-
5.2.4. SETUP Menu................................ ................................ ..29
5.2.5. SAVE/RESTORE Menu................................ ..................29
6. Errors and Recovery.................................................................................30
6.1. Error Messages in MIO front panel ................................ ...............30
6.2. Error Messages on Paper ................................ ............................. 31
6.3. Two Devices with Same Address................................ .................. 31
7. Function Selection via the Line............................................................... 32
7.1. The Escape Character ................................................................ ..32
7.2. Defining a Temporary Escape Character ......................................33
7.3. Syntax of an FSL Function ................................ ............................ 34
7.4. Supported FSL Functions ................................ ............................. 34
7.5. Invalid Escape Sequence ................................ ............................. 34
8. FSL Setup via PC's parallel port.............................................................. 35
Limitations when Y249 is active ................................ ................36
8.1. Updating firmware ................................ ................................ .........36
9. Font Selection........................................................................................... 37
Scalable Fonts ................................ ................................ ..................... 39
10. Test Settings Printout............................................................................41
List of Abbreviations....................................................................................42
APPENDIX A - FSL Functions.....................................................................43
Appendix B. DIP Switch Settings................................................................ 53
Index..............................................................................................................54