User manual
Table Of Contents
- Front page
- Warnings/Approvals
- Addresses
- Preface
- Table of Contents
- 1. Introduction to the ida 812-1x MIO
- 2. Installing the ida 812-1x MIO Interface
- 3. Installing the ida 812-1x MIO Printer
- 4. ida 812-1x MIO Operation
- 5. Front Panel Setup
- 6. Errors and Recovery
- 7. Function Selection via the Line
- 8. FSL Setup via PC's parallel port
- 9. Font Selection
- 10. Test Settings Printout
- List of Abbreviations
- APPENDIX A - FSL Functions
- Appendix B. DIP Switch Settings
- Index
- READER'S COMMENTS
ida 812-1x MIO Operator’s Guide
Installation
-17-
6. Turn printer power OFF and set the Device Address switch as
described in Section 3.2, Printer Configuration Procedure and
according to the new emulation.
7. Connect the twinax cable and turn printer power ON.
3.5.
System Configuration
To obtain access to all the features of the ida 812-1x MIO on the
AS/400 and System /38 the printer should be configured as a 3812
Model 1 printer.
On System /36 the printer should be configured as a 5219 DO1 or
DO2 printer.