Installation Guide

085-00000590_01
10
Connect the VAC and Impact Sensor cables pin connectors to their
respective ports.
9
If the VAC and Impact Sensor cables are being routed along the
mounting surface, route the cables through the slot at the base of the
VAC bracket. Attach the bracket to the vehicle using the supplied
bolts and nuts. Proceed to Step 10.
Use supplied hardware:
11
Slide the VAC onto the bracket and
secure using the supplied nuts and
threaded studs.
Use supplied nuts:
M5 Serrated Hex Nut
M6 X 1.0 X 25 mm
Socket Head Screw
Underside of Vehicle
Mounting Surface
Topside of Vehicle Mounting Surface
M6
Nylon Lock Nut
M6
ID Washer
M6
ID Washer
The 10-pin VAC cable
connector to port C101.
The 8-pin Impact Sensor cable
connector to port C103.
Vehic
VAC4 Installation
PowerBox
TM
Note: Verify that the connector
latches are engaged to ensure that
the cables are secured to the VAC.
Slot at base of VAC bracket
to be used for cable routing
D
D
11
Slide the VAC onto the bracket and
Slide the VAC onto the bracket and
secure using the supplied nuts and
secure using the supplied nuts and
threaded studs.threaded studs.
D
D
R
Connect the VAC and Impact Sensor cables pin connectors to their
respective ports.
respective ports.
R
Note: Verify that the connector
latches are engaged to ensure that
the cables are secured to the VAC.
A
Connect the VAC and Impact Sensor cables pin connectors to their
Connect the VAC and Impact Sensor cables pin connectors to their
A
A
M6 X 1.0 X 25 mm
M6 X 1.0 X 25 mm
Socket Head Screw
Socket Head Screw
Topside of Vehicle Mounting Surface
M6
ID Washer
ID Washer
F
F
F
F
F
F
F
F
Underside of Vehicle
Mounting Surface
T
VAC bracket. Attach the bracket to the vehicle using the supplied VAC bracket. Attach the bracket to the vehicle using the supplied
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T