Installation Guide

3/8")
(2
085-00000590_01
3
5
(17/64")
Remove the bracket. Using a 6.75 mm
(17/64") bit, drill holes at the two
marked locations.
Using the bracket base as a template, mark the mounting hole
locations on the vehicle mounting surface, as shown below. Verify
that the marked locations are 60 mm (2 3/8") apart.
The VAC mounting bracket can be configured in multiple ways to
accomodate the desired mounting location. If needed, change the
VAC mounting bracket orientation by following the instruction sheet
supplied with the bracket.
4
(1”)
(optional center hole)
If the VAC to vehicle and Impact Sensor cables
will be routed through the vehicle’s mounting
surface, drill a 25 mm (1”) hole at the exact
center point between the two holes marked in
Step 4 [30 mm (1 3/16”) from either hole].
If the cables will be routed along the vehicle’s
mounting surface, do not drill a center hole and
skip to Step 9.
60 mm
6.75 mm
25 mm
Vehic
VAC4 Installation
PowerBox
TM
D
If the VAC to vehicle and Impact Sensor cables
If the VAC to vehicle and Impact Sensor cables
will be routed through the vehicle’s mounting
will be routed through the vehicle’s mounting
surface, drill a 25 mm (1”)
surface, drill a 25 mm (1”)
center point between the two holes marked in
center point between the two holes marked in
Step 4 [30 mm (1 3/16”) from either hole].
Step 4 [30 mm (1 3/16”) from either hole].
R
Remove the bracket. Using a 6.75 mm
Remove the bracket. Using a 6.75 mm
(17/64") bit, drill holes at the two
(17/64") bit, drill holes at the two
marked locations.marked locations.
R
A
A
A
A
3/8
")
A
A
A
A
Remove the bracket. Using a 6.75 mm
Remove the bracket. Using a 6.75 mm
A
A
60 mm
60 mm
F
F
F
F
F
F
that the marked locations are 60 mm (2 3/8") apart.
T
Using the bracket base as a template, mark the mounting hole
Using the bracket base as a template, mark the mounting hole
locations on the vehicle mounting surface, as shown below. Verify
locations on the vehicle mounting surface, as shown below. Verify
VAC mounting bracket orientation by following the instruction sheet
VAC mounting bracket orientation by following the instruction sheet
T