User Manual

Installation
I.D. Systems, Inc. One University Plaza, Hackensack, NJ 07601 000-0144-01
Tel: [phone]; Fax [phone]; email: [e-mail] Page 33 of 42
Present Battery ID
To begin…
*Cancel*
Battery Validation:
Battery Validation:
After an operator presents his/her prox-card, the
operator is prompted to present a valid Battery
Prox-card.
Touch the prox-card or prox-fob attached to the
newly added battery to the VAC’s prox-reader to
proceed. (Note: Only valid battery prox ID’s will
be accepted)
If there is no prox-card or prox-fob on the new
battery, contact maintenance to proceed.
Battery Request Troubleshooting:
If the ‘Requesting..’ indicator continues to blink for more than 10 seconds, operator should attempt to
move vehicle closer to a Gateway.
If operator is near a Gateway but the ‘Requesting..’ indicator blinks for more than 30 seconds, there is
most likely a problem with that Gateway. The operator should move to another Gateway or consider
proceeding with a manual swap. An administrator should be alerted to this condition.
If the ‘Requesting..’ indicator disappears, but no page arrives on the VAC for 30 seconds after the request
is submitted, the network is likely to be down, or the ARDCS is not running. The operator should
consider proceeding with a manual swap. An administrator should be alerted to this condition.
Security Module (Optional Module - All Users)
An optional module geared towards demands of high security installations analyzes individual vehicle use
and posts warnings on the ARDCS and on the vehicle when suspicious activities take place.
Using the high security module, system-wide “forbidden zones” can be set up using the Console (see
WANConsole User’s Guide) and also pre-programmed into the VAC. If any vehicle enters such a zone,
an alert will immediately be raised on the ARDCS (see ARDCS User’s Guide) and Graphical Viewer (see
WANConsole User’s Guide). In addition, an attached Security LED and on-screen text will indicate the
source of the security issue as follows:
Security Issue LED Blink Rate LCD Text