User's Manual

UTP 1.0 Installation & Verification Instructions

I.D. Systems Confidential and Proprietary

055-00000889 Rev A

4) If the vehicle alarm should sound during installation, use the key fob to unlock the doors

and disable the alarm.

5) Once the UTP 1.0 connector is plugged in, the green LED light on the connector will

begin to flash. It will take approximately 3.5 minutes to in-fleet successfully. (See LED

Indicators for more information.)

• LED Pattern: Quick blink for 3 minutes, then periodic flashing for 30 seconds before

the LED turns solid green.

• If the LED on the UTP 1.0 connector turns red, make sure the car/vehicle is a

certified make/model.

6) When the UTP 1.0 in-fleets successfully (the LED turns solid green), the enclosure is

ready to be routed under the dash and tie-wrapped to a wire harness. When searching

for a wire harness, locate a thick, immovable location.

• Avoid installing the UTP 1.0 in the brake or gas pedal areas. Also, avoid installing on

loose wire harnesses.

Locate a wire harness

Solid green LED indicates successful in-fleet