User's Manual

UTP 1.0 Installation & Verification Instructions

I.D. Systems Confidential and Proprietary

055-00000889 Rev A

The material contained in this document is protected by the copyright and trade secret laws of

the United States and other countries. It may not be reproduced, distributed, or altered in any

fashion by any entity (either internal or external to I.D. Systems, except in accordance with

applicable agreements, contracts, or licensing, without the express written consent of the Brand

or Marketing Communications Director or the business management owner of the material.

Disclaimer and Limitations of Liability

The information contained in this Guide is subject to change without notice and should not be

construed as a specification.

NOTICE: This device complies with Part 15 of the FCC Rules and with Industry Canada

license-exempt RSS standard(s)].

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

NOTICE: Changes or modifications made to this equipment not expressly approved by

I.D. Systems may void the FCC authorization to operate this equipment.

To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the

antenna(s) used for this transmitter must be installed to provide a separation distance of at least

20 cm from all persons and must not be co-located or operating in conjunction with any other

antenna or transmitter.