User's Manual

Find a wire harness for mounting the MVAC within 2 feet
of the OBD port. Once installed, the MVAC must NOT interfere
with the driver’s operation of the vehicle (pedals, steering,
etc.). Make sure the weight of the MVAC will not damage or
pull out the cables from their connectors. If the MVAC is
installed against a vehicle surface (e.g. metal plate), verify
that the I.D. Systems logo is facing against the surface, so
that the clip side is visible and accessable after installation.
Slide back the locking pin
and push back on the
clamp lock to release the
snap clamp.
3/8-inch
actual
3/4-inch
actual
MINIMUM SIZE <--- BUNDLE ---> MAXIMUM SIZE
Push down
Removing the Unit from the Vehicle
(refer to install instructions
for image references)
Electrical ConnecƟons (Cont.)
Motor Vehicle Asset Communicator™
Confidentiality Notice © 2012 I.D. Systems, Inc. All rights reserved. This document contains confidential and/or proprietary information and may be reproduced for internal purposes only. This document may not be
reproduced in part, or shown, or in any way disclosed to any third party, without the express written consent of I.D. Systems, Inc.
3
!
Unplug the MVAC from the OBD port.
Remove the the key from the ignition.
4
When open, the MVAC
will look like this with the
pin out and the clamp released
5
Slide the pin back
in place to lock the clamp
Tightly clip the MVAC latch around the
cable/wire harness that has a diameter
of ⅜” to ¾”. Make sure the MVAC does
not slide or rub against the wires. If it does,
use a thicker bundle.
6
Route the MVAC cord to the OBD port. Wrap the cord
around cables and the OBD port where possible to
ensure it does not interfere with the driver’s operation
of the vehicle. Then plug it into the OBD port.
7
• Remove key from vehicle
• Unplug MVAC from OBD port
• Put the OBD plug taped to the
MVAC harness back into the OBD
port (if it exists)
• Unwrap MVAC cord as required
• Pull back the locking pin
• Open the mounting latch
• Remove MVAC
• Store MVAC for future use
!
!
A RentalFleet
TM
System Device
093-00000076 Rev 02
NOTE: Secure the MVAC so that it will not cause
rattles, knocks, or vibrations. Carefully avoid
contact or interference with the Park Brake
Mechanism, Steering Knuckles, or any other
moving parts. Avoid areas near heater outlet
vents. If needed, use large nylon cable ties to
mount the MVAC in a safe and secure position.