User's Guide
Table Of Contents
- COVER
- COPYRIGHT
- 1. INTRODUCTION
- 2. SAFETY PRECAUTIONS
- 3. OPERATING PRECAUTIONS
- 4. PREPARATION
- 5. IDENTIFYING MODEL TYPE
- 6. EACH PART OF PRINTER
- 7. LED INDICATION OF PRINTER
- 8. INSTALLING BATTERY PACK
- 9. LOADING THERMAL PAPER
- 10. TEST PRINT
- 11. FUNCTION SETTINGS
- 12. CONNECTING TO HOST DEVICE
- 13. INSTALLING BELT CLIP / SHOULDER STRAP
- 14. CHARGING BATTERY PACK
- 15. CHARGING BY CRADLE
- 16. CHARGING BY CAR CHARGER
- 17. CHARGING BY BATTERY CHARGER
- 18. PRINTER MAINTENANCE
- 19. TROUBLESHOOTING
- 20. SPECIFICATIONS
- 21. ACCESSORIES AND CONSUMABLE PARTS
- 22. MS SETTINGS LIST
- REAR COVER
53
16. CHARGING BY CAR CHARGER
The battery pack can be charged by connecting a car accessory socket and the printer using the car
charger.
The car charger is only for charging. Even when the car charger is connected to the printer, the printer
cannot print without the battery pack.
Charging the battery pack by the car charger is possible while the car engine is running or in the
accessory position. Ensure that the car battery remaining capacity is sufficient before using the car
charger in accessory position.
The car charger is an optional accessory. See "20 SPECIFICATIONS" and "21 ACCESSORIES AND
CONSUMABLE PARTS", and be sure to purchase our specified accessories listed on these references.
NOTE
◆
DO NOT remove the battery pack during charging.
◆
DO NOT connect the battery charger to the car charger.
◆
The battery pack should be charged at 0°C to 40°C (32°F to 104°F).
◆
After using the car charger, be sure to unplug the cigar plug from the car accessory
socket.
◆
DO NOT print out during a vehicle driving. Ejected thermal paper may hinder driving of
the vehicle.