User's Guide
Table Of Contents
- COVER
- COPYRIGHT
- 1. INTRODUCTION
- 2. SAFETY PRECAUTIONS
- 3. OPERATING PRECAUTIONS
- 4. PREPARATION
- 5. IDENTIFYING MODEL TYPE
- 6. EACH PART OF PRINTER
- 7. LED INDICATION OF PRINTER
- 8. INSTALLING BATTERY PACK
- 9. LOADING THERMAL PAPER
- 10. TEST PRINT
- 11. FUNCTION SETTINGS
- 12. CONNECTING TO HOST DEVICE
- 13. INSTALLING BELT CLIP / SHOULDER STRAP
- 14. CHARGING BATTERY PACK
- 15. CHARGING BY CRADLE
- 16. CHARGING BY CAR CHARGER
- 17. CHARGING BY BATTERY CHARGER
- 18. PRINTER MAINTENANCE
- 19. TROUBLESHOOTING
- 20. SPECIFICATIONS
- 21. ACCESSORIES AND CONSUMABLE PARTS
- 22. MS SETTINGS LIST
- REAR COVER
43
(5) As shown in Figure 13-9, install the other side in the same procedure described (3) to (4).
Figure 13-9 Shoulder Strap Installation (5)
NOTE
◆
Be sure to install the shoulder strap to the printer securely when using it. Dropped
printer may cause personal injury or malfunction.
◆
Avoid the direct skin contact with the battery pack while using the shoulder strap.
Prolonged skin contact may cause low-temperature burns.