User's Guide
Table Of Contents
- COVER
- COPYRIGHT
- 1. INTRODUCTION
- 2. SAFETY PRECAUTIONS
- 3. OPERATING PRECAUTIONS
- 4. PREPARATION
- 5. IDENTIFYING MODEL TYPE
- 6. EACH PART OF PRINTER
- 7. LED INDICATION OF PRINTER
- 8. INSTALLING BATTERY PACK
- 9. LOADING THERMAL PAPER
- 10. TEST PRINT
- 11. FUNCTION SETTINGS
- 12. CONNECTING TO HOST DEVICE
- 13. INSTALLING BELT CLIP / SHOULDER STRAP
- 14. CHARGING BATTERY PACK
- 15. CHARGING BY CRADLE
- 16. CHARGING BY CAR CHARGER
- 17. CHARGING BY BATTERY CHARGER
- 18. PRINTER MAINTENANCE
- 19. TROUBLESHOOTING
- 20. SPECIFICATIONS
- 21. ACCESSORIES AND CONSUMABLE PARTS
- 22. MS SETTINGS LIST
- REAR COVER
39
13. INSTALLING BELT CLIP / SHOULDER STRAP
The belt clip and the shoulder strap convenient for carrying the printer can be attached to this printer.
The belt clip is included with the printer at the factory shipment, but is also available as an optional
accessory.
The shoulder strap and the strap attachment are optional accessories. See "21 ACCESSORIES AND
CONSUMABLE PARTS", and be sure to purchase our specified accessories listed on the reference.
Installing Belt Clip
(1) Turn off the printer.
(2) Remove the battery pack from the printer.
When the AC adapter is connected, unplug the AC plug of the AC adapter from the outlet.
(3) Insert the part "d" of the belt clip into the hole "D" of the printer in the direction of the arrow as
shown in Figure 13-1.
The belt clip cannot be installed if inserted in the wrong direction.
Figure 13-1 Belt Clip Installation (1)
(4) Rotate the belt clip 90 degrees and level it.
Figure 13-2 Belt Clip Installation (2)
D
d