User's Guide
Table Of Contents
- COVER
- COPYRIGHT
- 1. INTRODUCTION
- 2. SAFETY PRECAUTIONS
- 3. OPERATING PRECAUTIONS
- 4. PREPARATION
- 5. IDENTIFYING MODEL TYPE
- 6. EACH PART OF PRINTER
- 7. LED INDICATION OF PRINTER
- 8. INSTALLING BATTERY PACK
- 9. LOADING THERMAL PAPER
- 10. TEST PRINT
- 11. FUNCTION SETTINGS
- 12. CONNECTING TO HOST DEVICE
- 13. INSTALLING BELT CLIP / SHOULDER STRAP
- 14. CHARGING BATTERY PACK
- 15. CHARGING BY CRADLE
- 16. CHARGING BY CAR CHARGER
- 17. CHARGING BY BATTERY CHARGER
- 18. PRINTER MAINTENANCE
- 19. TROUBLESHOOTING
- 20. SPECIFICATIONS
- 21. ACCESSORIES AND CONSUMABLE PARTS
- 22. MS SETTINGS LIST
- REAR COVER
36
USB Interface
(1) Ensure that the printer is off.
(2) Open the cover of the USB connector on the printer, and connect the USB cable plug to the USB
connector as shown in Figure 12-1.
Figure 12-1 Printer and USB Cable Connection
(3) Turn on the printer, and send data from the host device to the printer.
(4) Verify that the data is printed correctly.
NOTE
◆
When connecting the USB cable to the USB connector, push the plug to the end.
◆
When connecting or disconnecting the cable, hold the plug. Never pull the cable.