User's Guide
Table Of Contents
- COVER
- COPYRIGHT
- 1. INTRODUCTION
- 2. SAFETY PRECAUTIONS
- 3. OPERATING PRECAUTIONS
- 4. PREPARATION
- 5. IDENTIFYING MODEL TYPE
- 6. EACH PART OF PRINTER
- 7. LED INDICATION OF PRINTER
- 8. INSTALLING BATTERY PACK
- 9. LOADING THERMAL PAPER
- 10. TEST PRINT
- 11. FUNCTION SETTINGS
- 12. CONNECTING TO HOST DEVICE
- 13. INSTALLING BELT CLIP / SHOULDER STRAP
- 14. CHARGING BATTERY PACK
- 15. CHARGING BY CRADLE
- 16. CHARGING BY CAR CHARGER
- 17. CHARGING BY BATTERY CHARGER
- 18. PRINTER MAINTENANCE
- 19. TROUBLESHOOTING
- 20. SPECIFICATIONS
- 21. ACCESSORIES AND CONSUMABLE PARTS
- 22. MS SETTINGS LIST
- REAR COVER
35
12. CONNECTING TO HOST DEVICE
The printer supports the USB interface and the Bluetooth interface or Wireless LAN interface.
Selecting Bluetooth interface or Wireless LAN interface depends on the model.
Order the model of communication method to use from the following.
• Bluetooth model (MP-B30-Bxxxxxx) : Bluetooth interface + USB interface
• Wireless LAN model (MP-B30-Wxxxxxx) : Wireless LAN interface + USB interface
The communication speed may be decreased depending on processing by software or print contents.
The interface is required to be set to USB in places where emitting radio waves is prohibited.
To temporarily switch the interface, press the POWER Switch 3 times within 3 seconds while the printer
is on.
The WIRELESS LED lights on or blinks when wireless communication is enabled.
The WIRELESS LED lights off when wireless communication is disabled.