User's Guide

34
(6) A message for selecting the setting value of the selected function is printed as a sample shown in
Figure 11-4.
Press the FEED Switch the number of times corresponding to the selected setting value number,
and then press the POWER Switch.
・When pressing the FEED Switch once, "1 : Enable" is selected.
Figure 11-4 Setting Value Selection Message
(Example: Selected Error Through)
(7) A message for confirming the selected setting value is printed as a sample shown in Figure 11-5.
Figure 11-5 Setting Value Confirmation Message
(Example: Selected Enable)
Press the FEED Switch to save the setting value to the memory. Figure 11-2 is printed.
Press the POWER Switch to discard the selected item. A message of the function selection is
printed as a sample shown in Figure 11-3. If select "0 : Return to MS Selection" there, function
selection is not performed, and Figure 11-2 MS Selection Message is printed.
To continue to set functions, return to (4).
(8) To exit the Setting Mode, select "0 : Exit" in Figure 11-2.
The test print and Figure 11-1 printing start again. Verify that the functions are properly set.
To return to the print-ready status, select "0 : Normal Mode" in Mode Selection Message.
To set functions again, return to (3).
[Error Through]
0 : Return to function selection
1 : Enable
2 : Disable
Press the FEED switch an equal
number of times to the selected number.
After that, press the POWER SW.
[Error Through]
Set Enable
Save setting : Feed SW
Discard setting : Power SW