User's Guide
Table Of Contents
- COVER
- COPYRIGHT
- 1. INTRODUCTION
- 2. SAFETY PRECAUTIONS
- 3. OPERATING PRECAUTIONS
- 4. PREPARATION
- 5. IDENTIFYING MODEL TYPE
- 6. EACH PART OF PRINTER
- 7. LED INDICATION OF PRINTER
- 8. INSTALLING BATTERY PACK
- 9. LOADING THERMAL PAPER
- 10. TEST PRINT
- 11. FUNCTION SETTINGS
- 12. CONNECTING TO HOST DEVICE
- 13. INSTALLING BELT CLIP / SHOULDER STRAP
- 14. CHARGING BATTERY PACK
- 15. CHARGING BY CRADLE
- 16. CHARGING BY CAR CHARGER
- 17. CHARGING BY BATTERY CHARGER
- 18. PRINTER MAINTENANCE
- 19. TROUBLESHOOTING
- 20. SPECIFICATIONS
- 21. ACCESSORIES AND CONSUMABLE PARTS
- 22. MS SETTINGS LIST
- REAR COVER
30
(3) A message of mode selection is printed as shown in Figure 10-5 when the test print has completed.
To print Wireless LAN information, select "4 : Print WLAN Information". (Press the FEED Switch 4
times, and then press the POWER Switch.)
The printer starts preparation for printing Wireless LAN information.
Figure 10-5 Mode Selection Message (Wireless LAN Model)
(4) The information acquisition message in Figure 10-6 is printed until the printing of Wireless LAN
information starts.
Figure 10-6 Wireless LAN Information Acquisition Message
After completing acquisition Wireless LAN information, Wireless LAN information is printed as a
sample shown in Figure 10-7.
Figure 10-7 Wireless LAN Information Print Example
[Mode Select]
0 : Normal Mode
1 : Setting Mode
2 : Wireless ON/OFF Mode
3 : Hex Dump Mode
4 : Print WLAN Information
Press the FEED switch an equal
number of times to the selected number.
After that, press the POWER SW.
Getting WLAN information. Please wait...
* WLAN Communication *
Mode: Simple AP
Radio: 802.11b/g/n
Country: US
Channel: Auto
SSID: SII-Printer
Security: None
MAC Address: XX:XX:XX:XX:XX:XX
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
Default Gateway: 0.0.0.0
Module Ver.: 01.XX