Instructions / Assembly

25.

1. Disconnect and remove the spark plug using a wrench.

2. Inspect the spark plug and clean any dirt or debris from the elec-

trodes with a wire brush. Replace if the electrodes are worn or the

insulator is damaged.

3. Measure the electrode gap with a spark plug gauge or feelers

and adjust as necessary by carefully bending the side electrode.

Thegaphastobebetween0.7-0.9mm.(RefertoFig.5.4)

4. Install the plug carefully by hand. Then tighten it with a spark

plug wrench.

Fig. 5.4

CAUTION

Tighten 1/8-1/4 turn when re-installing an old spark plug.

Spark Plug

Wrench

0.7-0.9 mm

gap distance

Side Electrode