Instructions / Assembly

16.
EN
4. OPERATION
4.1: Starting the engine
1.Primethepump.(RefertoFig.4.1.1)
2.SlidethefuelvalvelevertotheONposition.(RefertoFig.4.1.2)
3.SlidethechokelevertotheCLOSEposition.(RefertoFig.4.1.2)
4. Adjust the throttle lever to about ¼ of the way to the left direction.
(RefertoFig.4.1.3)
5.TurntheengineswitchtotheONposition(RefertoFig.4.1.4)
6. Pull the starter grip gently until resistance is felt. Then pull it
briskly and the engine should start. Repeat the process if the en-
ginedoesnotstart.(RefertoFig.4.1.5)
7.Aftertheenginewarmsup(above50
o
F), turn the choke lever to
the OPEN position.
Fig. 4.1.1
CAUTION
Make sure that the priming water and the container are
free of any debris.
WARNING
Opening the throttle immediately after starting the pump
will not provide enough time for the parts to lubricate.
Priming Cap