User Manual

EM -22 ENGINE MECHANICAL SYSTEM
NOTE
Do not remove the cam sensor plate (2), if it is not
damaged.
2. When removing the camshaft assembly (1), han-
dle cam bush carefully not to be damaged.
1
SUDEM7035L
16. Remove the front plate (1).
1
SUDEM7036L
CAUTION
When removing the front plate (1), do not remove
the bolts (2) processed with spacers.
If they were removed, assemble them based on
the dowel pin and then sealant must be applied
between front plate and spacers.
1
2
SUDEM7037L
INSPECTION EB5EDDCB
1. Measure inner diameter of idler gear (1) and outer
diameter of idler shaft (2). If the gap exceeds the limit,
replace the idler gear bush.
Reference gap between idler bush and idler shaft ([
]indicates reference diameter): [45] 0.025~0.06mm
Limit: 0.1mm
1
2
SUDEM7038L
2. Measure cam max (1) and min diameter (2). Replace
the camshaft assembly, if it exceeds the limit.
N
OTE
The difference between the max and min diameter is
theliftofthecam