Operation and maintenance manual

www.changlin.com.cn


96/167
pages

Clean the gasket surfaces.
NOTE: Do not let any debris fall into the thermostat
cavity when cleaning gasket surface.
Caution: Always use the correct thermostat and
never operate the engine without a thermostat. An
incorrect thermostat can cause the engine to
overheat or run too cold. The engine will overheat if
operated without a thermostat because the coolant
flows back to the inlet of the water pump instead of
through the radiator for cooling.
Assemble the removed parts in the reverse order of
removal.
Make sure the gasket is aligned with the cap screw
holes. Install the cap screws and use your fingers to
tighten.
The notched end of the rubber thermostat seal points
away from the cylinder head.
10 mm
Tighten all Cap screws.
Torque Value: 24 N*m [18 ft-lb]