Operation and maintenance manual

www.changlin.com.cn


90/167
pages

RepairToolsRequired
S
ockets Wrenches
O
the
r
10 mm Allen Wrench (8 mm)
12 mm 8 mm Breaker Bar (1/2 in. Sq. Drive)
13 mm 10 mm Flat Screwdrive
r
15 mm 13 mm Ratchet (3/8 in. Sq. Drive)
17 mm 15 mm Ratchet (1/2 in. Sq. Drive)
18 mm 17 mm (open end) Filter Wrenches (75-80 mm and 90-95 mm)
19 mm 19 mm Drill Motor (1/4 inch)
22 mm 22 mm Drill Bit (3 mm)
27 mm 24 mm Slide Hamme
r
Flat Chisel T-Bar Puller (75mm)
Sheet Metal Screw (#10) Torque Wrench Pliers
Engine Barring Gear 3377371
Cooling System Repair Summary
Component To Be Replaced Tools Preparatory Steps'
Drive Belt Breaker Bar (3/8 inch Square drive)
Belt Tensioner Ratchet (3/8 inch drive) Remove Drive Belt
15mm Socket and Torque Wrench
10 mm Socket/Wrench Remove Drive Belt and Pulley
10 mm Socket/Wrench Drain Coolant and Remove Drive
Belt
10 mm, 18 mm and 19 mm
Socket/Wrench
Drain Coolant, Remove Drive
Belt, Loosen Alternator Link,
Remove Alternator Mounting
Cap screw, Remove Thermostat
Housing