Operation and maintenance manual
www.changlin.com.cn
62/167
pages
Intall the pressure cap. Operate the engine until it reaches a temperature of 80°C [180°F], and check for
coolant leaks.
Check the coolant level again to make sure the system
is full of coolant, or that the coolant level has risen to
the hot level in the recovery bottle on the system, if so
equipped.
Warning: Before removing the pressure cap, wait until
the coolant temperature is below 50 °C [120°F]. Failure
to do so can cause personal injury from heated coolant
spray.
VibrationDamper(Rubber)
Inspection
Check the index lines (A) on the damper hub (B) and
the inertia member (C). If the lines are more than 1.59
mm [1/16 inch] out of alignment, replace the damper.
Inspect the rubber member for deterioration. If pieces of
rubber are missing or if the elastic member is more than
3.18 mm (1/8 inch] below the metal surface, replace the
damper.
NOTE: Also look for forward movement of the damper
ring On the hub. Replace the damper if any movement is
detected.