Operation and maintenance manual
www.changlin.com.cn
56/167
pages
DriveBeltInspection
Inspection
3/8 Inch Square Drive, 13 mm
Remove the drive belt.
Lift the tensioner to remove and install the belt.
NOTE: After the tensioner has been raised to
remove/in- stall the belt, check the torque of the
tensioner cap screw.
Torque Value: 43 N*m [32 ft-lb]
Inspect the belt for damage.
Transverse (across the belt width) cracks are
acceptable. Longitudinal (direction of belt length)
cracks that intersect with Transverse cracks are not
acceptable.
Replace the belt if is has unacceptable cracks, if
frayed or has pieces of material missing.