Operation and maintenance manual
www.changlin.com.cn
53/167
pages
Caution: To prevent damage to the engine or pin, be
sure do disengage the pin after locating TDC.
Feeler Gauge
Intake Clearance: 0.254 mm [0.010 IN]
Exhaust Clearance: 0.508 mm [0.020 IN ]
Check/set valves with engine cold-below
60°C [140°F].
NOTE: The clearance is correct when some
resistance i “felt” when the feeler gauge is
slipped between the valvi stem and the
rocker lever.
FourCylinderEngineAdjustment
14 mm, Flat blade Screwdriver
Locate Top Dead Center (TDC) for Cylinder Number 1.
Check / adjust the valves as indicated in the illustration (1 =
Intake; E = Exhaust).
Tighten the locknut and measure the valve lash again. Torque
Value: 24 N*m [18 ft-lb]