Operation and maintenance manual

www.changlin.com.cn


127/167
pages

NOTE: A diesel engine can not tolerate dirt or water
in the fuel system. A tiny piece of dirt or a few
drops of water in the injection system may stop
your units.
Clean all external surfaces of the injection pump,
including all line connections and fittings that are to
be disconnected. Clean the area around the
injection pump gear cover to prevent dirt from
entering the crankcase.
Injection Pump-Removal 3377371
Engine Barring Gear
Locate TDC for cylinder No. 1. Push the TDC pin
into the hole in the camshaft gear while slowly
barring the engine.
NOTE: Be sure to disengage the pin after locating
TDC.
10 mm
Remove the fuel pump mounting bracket.
30 mm (P7100 Pump)
Remove the gear cover access cap.
Remove the nut and washer from the fuel pump
shaft.