Operation and maintenance manual
www.changlin.com.cn
109/167
pages
5/16 Inch
Install the cover and gasket onto the fuel injection
pump.
NOTE: Extreme care must be taken in assembling the
cover to a fuel injection pump to make sure the shutoff
arm is in proper with the linkage hook tab.
Install the cover to pump at a downward angle from
the drive shaft end of the fuel injection pump, then
slide the cover horizontally into position.
Torque Value: 4.6 N*m [41 in-lb]
KSB Replacement T30 TORX, 12 mm
Disconnect the wiring harness from the KSB solenoid
(1). Disconnect the fuel lines (2). Replace the KSB,
fuel lines and wiring harness.
Torque Value:
Fuel Line Banjo Fittings: 12 N*m [9 ft-lb]
KSB Mounting Nuts 9 N*m [7 ft-lb]
KDBTemperatureSwitchReplacement
27 mm
Disconnect the KSB (1) wiring harness (2) from
the switch (3). Replace the temperature switch.
Install the wiring harness.
Torque Value: 24 N*m [18 ft-lb]
FuelPump‐Replacement
Preparatory Steps:
• Remove all fuel lines.
• Remove control linkage.
• Remove fuel shut off solenoid.