OWNER'S MANU AL MANUAL AND INST ALLA TION GUIDE INSTALLA ALLATION CAR CD MP3 PLAYER RECEIVER SUB ACD-91 AM/FM/MPX RADIO WITH DETACHABLE FRONT PANEL COMPACT DISC PLAYER, MP3 PLAYBACK, CD CHANGER CONTROLS AND QUARTZ CLOCK
INST ALL AT ION INSTRUC INSTALL ALLA INSTRUCTT IONS INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, trucks, and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialist shops. Always check the kit application before purchasing to make sure the kit works with your vehicle.
DAY MON. - FRI.
R A DIO WIRING RADIO WIRING REFER TO PAGE 5 FOR SPEAKER WIRING ANTENNA AUTOMATIC ANTENNA BLUE IMPORTANT THE BLUE WIRE CAN BE USED TO REMOTELY ACTIVATE AN AUTOMATIC ANTENNA OR AN EXTERNAL AMPLIFIER (SEE ANTENNA OR AMPLIFIER MANUAL) EXISTING ANTENNA CABLE “RADIO” FUSE + 12V ACCESSORY RED 1-AMP FUSE BLACK FUSEBLOCK SCREW METAL PART OF DASH (DRILL HOLE IF NECESSARY) CAR BATTERY YELLOW IMPORTANT FILTER/FUSE BOX 15-AMP FUSE 4 PIN PLUGS ANTENNA PLUG 9 PIN PLUG (SEE PAGE 5 FOR SPEAKER WIRING) ANTENNA
WARNING! ! THE AMPLIFIERS IN THIS RADIO ARE ONLY DESIGNED FOR USE WITH 4 SPEAKERS. ! NEVER COMBINE (BRIDGE) OUTPUTS FOR USE WITH 2 SPEAKERS. ! NEVER GROUND NEGATIVE SPEAKER LEADS TO CHASSIS GROUND. ! FAILURE TO WIRE EXACTLY AS SHOWN BELOW MAY CAUSE ELECTRICAL DAMAGE TO THE RADIO. REFER TO PAGE 4 FOR RADIO WIRING RCA LINE IN JACKS RCA LINE OUT FOR USE WITH JACKS AUXILIARY INPUT FOR USE WITH DEVICES (CD OPTIONAL PLAYER, ETC.
OPER AT ING INSTRUC OPERA INSTRUCTT IONS OPER AT ING INSTRUC OPERA INSTRUCTT IONS 34 19 20 32, 33 BEHIND PANEL 30 28 14 31 29 3 4 5 6 7 SUB CAR CD MP3 PLAYER RECEIVER 11 12 21 22 37 38 15 1 2 13 27 23 24 35 39 40 25 41 26 36 8, 10 18 17 9 16 1 ON-OFF POWER BUTTON Press this button to turn the unit on and off when the ignition switch is on. When the unit is off, the Liquid Crystal Display (LCD) panel will normally display the time-of-day.
5 TREBLE CONTROL To adjust the treble level, first select the Treble mode by pressing the PUSH SELECT button so the TRB indication appears on the display panel. Within 5 seconds of choosing the Treble mode, rotate the Volume Level control CCW or CW to adjust the treble response as desired. The level will be shown on the display panel from a minimum of --10 to a maximum of 10 (00 indicates flat response).
OPER AT ING INSTRUC OPERA INSTRUCTT IONS is active, the radio will seek the next strongest local station when either button is pressed. bn MANUAL SEEK TUNING This function is used to search rapidly upward or downward for a desired station. By pressing either tune button for more than 2 seconds, the radio will enter the MANUAL seek mode as displayed momentarily on the panel.
EQUALIZER (EQ) BUTTON The EQ button applies preset sound effects to the unit’s audio output signal.The EQ button, when pressed, will activate one of the following operating modes ( CLASSICS, POP M, ROCK M, DSP OFF or FLAT). If the Equalizer function is active, as displayed on the panel, and the bass and/or treble level is set, the Equalizer function reverts to the FLAT setting. On the other hand, if the Equalizer function is activated, the bass/ treble setting(s) are ignored.
OPER AT ING INSTRUC OPERA INSTRUCTT IONS co TRACK SCAN SELECTOR (SCN) During disc play, press this button to play the first 10 seconds of each track on the disc (S--SCN will appear on the display panel). When a desired track is reached, press the SCN button again to cancel the function (S--SCN will disappear from the display panel) and play of the selected track will continue. Scan mode will also be canceled by activating the Repeat Play , or Shuffle functions.
TIME/FREQUENCY (T/F) SELECTOR Pressing the Time/Frequency (T/F) button will display the time of day for 5 seconds, after which the display will automatically return to the radio, tape or CD changer display, depending on which one was currently active. To set the correct time of day, refer to the procedure for Setting the Clock. dn THEFT-DETERRENT LED Located on the chassis behind the front panel, a light-emitting diode (LED) will flash when the panel is removed.
SET OR CODES SETTT ING THE CLOCK/CD ERR ERROR SETTING THE CLOCK 1. Switch the vehicle ignition and radio on. 2. Momentarily press the Time/Frequency (T/F) Select button on the display panel. dm so that the time is shown 3. Press and hold the Time/Frequency button until the time display begins flashing. While ) button to adjust the hours and then the display is still flashing, press the Up Tuning ( ) button to adjust the minutes to the correct time. the Down Tuning ( 4.
Size: 7” W x 178 mm x 2” H x 6” D 50 mm x 150 mm Operating Voltage: 12 volts DC, negative ground Output Power: 160 watts maximum (40 watts x 4 channels) Output Wiring: Floating-ground type designed for 4 speaker use. The amplifiers in this unit are NOT designed for use with 2 speakers. RCA pre-amp level outputs. Output Impedance: Compatible with 4 - 8 ohm speakers Pre-Amp Output: 500 mv. Tuning Range: AM: 530 - 1,710 KHz. (10 KHz. step) FM: 87.5 - 107.9 MHz. (200 KHz.
NO TES ON DISCS NOTES NOTES ON DISCS: Attempting to use non-standard shape discs (e.g.; square, star, heart) may damage the unit. Be sure to use round-shape CDs only in this unit. NOTES ON CD-Rs (Recordable CDs)/CD-RWs (Rewriteable CDs): 1. Be sure to use discs with the following marks only for play in this unit: 2. The unit cannot play a CD-R or CD-RW that is not finalized. (Please refer to the manual of your CD-R/CD-RW software for more information on the finalization process.) 3.
dq CD CHANGER PAUSE/PLAY SELECTOR ( PAU ) During radio, or tape play, press the MODE button to select operation of the CD changer as shown by CDC on the display. Disc play will begin, the disc and track number will be shown on the display panel, and the center of the disc cu ) will become animated. If a new icon ( magazine has been loaded into the changer, play will begin from the first track of the first disc in the magazine.
CD CH A NGER CONTR OL S/CD ERR OR CODES CHA CONTROL OLS/CD ERROR el TRACK REPEAT PLAY SELECTOR (RPT) When the RPT button is momentarily pressed, the RPT indication will appear on the display panel and play of the current track will be continually repeated until the Track Repeat mode is canceled by pressing the RPT button again or by activating the Track Select, Random Play or Scan functions.
MP3 (Moving Picture Experts Group, Layer 3) are digital audio files that are compressed to about 1/10th the size of a CD recording. As a result, you can compress a CD song that has 50 megabytes of data into an MP3 that has only 4 or 5 megabytes. The ACD-91 can play MP3s directly from files contained on a CD-R/RW, by using the MP3 buttons on the radio (or an optional Remote Control).
MP3 PL AYBACK OPER AT ION PLA OPERA 5. Preset 3: This button functions in the same manner as Preset 1, except it represents alphanumeric characters G, H, I, 3. 6. Preset 4: This button functions in the same manner as Preset 1, except it represents alphanumeric characters J, K, L, 4. 7. Preset 5: This button functions in the same manner as Preset 1, except it represents alphanumeric characters M, N, O, 5. 8.
1. Press the ID3 (T/F) button until the ID Tag, if supported, is displayed. NOTE: The ID TAG can specify the Song name, Artist, Album, Year, and/or Comments. 2. If no ID TAG is available, --NO ID3 will appear on the display following Comments. SEARCHING BY TRACK NUMBER To search for a desired track directly, proceed as follows: 1.
MP3 PL AYBACK OPER AT ION / CA RE A ND MA INTENA NCE PLA OPERA CARE AND MAINTENA INTENANCE NAVIGATING FROM A ROOT OR SUB-DIRECTORY To search for a desired song from a root directory or a sub-directory on the MP3 CD, proceed as follows: 1. With the MP3 CD in play mode, press the MENU button until the root name is displayed for a second and the first sub-directory or file name is displayed. / buttons, but use the a. Search within the directory for the song title by using the first. b.
! The CD player is a precision instrument and will not operate properly in extreme hot or cold. In case of such conditions, wait until the interior temperature of the vehicle reaches a normal temperature before using the player. ! If the temperature inside the player gets too hot, a protective circuit will automatically stop play of the disc. In this case, allow the unit to cool off before operating the player again.
THIS PAGE LEFT BLANK INTENTIONALLY 22
AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
© 2003 Audiovox Electronics Corp.
