Operation Manual

Page 31
Always refuel in a well-ventilated area with the engine off.
Whilst carrying out maintenance you must wear appropriate Personal Protective Equipment (PPE)
when using this machine. Suggested PPE Sturdy footwear, work gloves (especially when working near
blade), long trousers and hearing protection.
System/
Component
Procedure
Each use
Every
25
hours
Every
50
hours
Every
100
hours
Fuel/oil leaks
Check and repair as
required.
○
Spillages.
Clear up all split fuel/oils.
○
Fuel tank, air filter.
Replace as required.
Inspect/clean.
○
○
Spark plug – Gap 0.6m
to 0.7mm.
Clean and adjust.
○
Cylinder fin intake air
cooling vent.
Clean.
○
Exhaust, spark arrester
and cylinder exhaust
port.
Clean.
○
Throttle trigger STOP
switch.
Check operation.
○
Cutting parts.
Check for sharpness -
sharpen/replace asrequired
.
○
Screws/nut/bolts (Not
adjusting screws).
Tighten and /or replace.
○
○
Cutting attachment
guard.
Make sure it is attached.
○
Chainsaw oiling port.
Clean.
○
Hedge trimmer gearbox
grease
Check and top up.
○
Trimmer head gearbox
grease
Check and top up.
○
Guide bar.
Clean.
○
Oiling point & sprocket.
Clear oiling port, inspect
sprocket and replace as
required.
○
Saw chain.
Inspect and sharpen.
○
Increase maintenance intervals if operating in dusty environments. Some maintenance operations must be performed by qualified service
personnel.
6. MAINTENANCE