Operation Manual

Page 21
2.14. Adding fuel.
2.15. Adding/checking chain oil.
Unscrew the fuel tank cap and carefully add a 2-stroke fuel/oil mixture as in section 2.12. DO
NOT overfill and allow a 25 mm gap at the top of the tank. Once full replace and correctly
tighten the fuel cap. Fuel tank capacity is800ml
DO NOT use straight unleaded petrol.
To fill with chain oil place unit on its side, undo chainsaw oil tank cap, fill with chain oil to
prescribed level. Chain oil tank capacity is 180ml.
You MUST check chain oil before each use. The oil reservoir has sufficient to provide about 40
minutes of cutting time (when set to minimum flow rate).