User's Manual

Report No: BWS-04-RF-0002
FCC ID : QUPSAVERCALL-3000
Date of Test : February 04, 2004
6. Receiving & Responding To an Alarm Notification Call
During an Alarm Notification Call, the call recipient will first hear which sensor/detector activated the
alarm, then the alarm Notification Message, and finally they will be Voice-Guided to respond to the
options in the table below, which the system will run twice.
• If there is a response,
Savercall-3000 will act depending upon receiver’s option selection(s)
• If a phone number is busy, or if there is no touch-tone response (DTMF signal) from a receiver
(= there is no response in 2times of voice guidance),
SAVERcall-3000 will try calling the next
phone number the system will run this process twice.
• This will repeat until a user responds, or until the last programmed phone number has been
called
User Function Voice Guide Press
Converse via 2-way
speakerphone
“To speak, no. 1” 1
Listen only, mute speakerphone
at the alarmed zone
“To wiretap, no. 2.” 2
Want to start Siren alarm “To start Siren, no. 3.” 3
Enter wait mode “To enter the wait mode, no. 4.” 4
Have Controller stop dialing the
programmed phone numbers
“To stop all dialing, no. 8” 8
To hang up the phone and dial
the next phone
“To hang up the phone and dial the
next, no.9”
9
Hear Voice guidance again “To hear repeatedly, press no. 0.” 0
7. To Enter Control Mode Remotely by Telephone
 SAVERCALL-3000 will receive a call from the outside.
 After you hear “ringer time” you set, you’ll enter Remote control mode.
 When
Saverca -3000 answers, you will hear: “ding, ding, ding”, then “Please input
password.”.
ll
 Press (Password)
 Follow the Voice-Guided instructions
Hyun Joung System Co., Ltd
Wireless Security System SAVERCALL-3000