User's Manual

Report No: BWS-04-RF-0002
FCC ID : QUPSAVERCALL-3000
Date of Test : February 04, 2004
If you assign “remote controller” as sensor no.1
Remote 01
L C D
1=ok 2=change
VOICE Remote controller, No.1, Press no.1 for selection, press no.2 for change.
If you want to select, press 1key. If you want to change, press 2key.
If you select the change (no.2), you will see the below message.
(1->30)Sensor No
L C D
=
VOICE Please input sensor number. Please press set key after finishing.
 Motion detector
Please turn on the Power Switch.
You will see LED blinking light
When you register “Motion detector”, please turn on switch.
Motion sensor
L C D
Sensor No=
VOICE
“Motion detector”, Please input sensor number. Please press set key after
finishing.
If you assign “Motion detector” as no.3(You can register sensor from no.1 to no. 30)
K E Y
3 + WAIT/SET
Motion detector
L C D
Sensor No=3
VOICE 3, the data is entered.
Hyun Joung System Co., Ltd
Wireless Security System SAVERCALL-3000