User's Manual

Report No: BWS-04-RF-0002
FCC ID : QUPSAVERCALL-3000
Date of Test : February 04, 2004
How to set up Main unit.
Initial setup
To activate WAIT/SET into the “Setting Mode” for the first time, follow the steps below:
1) Plug in A/C Adaptor to main controller
2) Turn on the main controller power in the back side with pressing WAIT/SET key
3) You will hear “ding” then you will enter setting mode.
4) Green LED will be blinking in the setting mode
0=Exit 1=ID 2=Sensor memory 3=Recording 4=Delaying alarm 5=Phone
number 6=Time 7=Others
L C D
Select >>
VOICE This is setting mode. Please select the function number.
* If you cannot see the above menu, please start from 2) after turning off system
Note: Please note that ‘1=ID’, ‘2=Sensor memory’, ‘3=Recording’, ‘5=Phone number’ are essential menu.
User must set up for normal working of this system.
Hyun Joung System Co., Ltd
Wireless Security System SAVERCALL-3000