User's Manual

DIB-500 R4.1 Safety regulations
Safety measures
24 Installation, Operation and Service Manual 90DIB500R41IM_FCC02 – 99.1
The operator of the product is responsible for damage to the product or damage caused
by the product if the product was used beyond the intended application range and/or
was not used as intended.
2.3 Safety measures
All the regulations listed in the following must be adhered to without fail:
| If extension cables or multiple socket outlets are used, make sure that they are
inspected for proper condition periodically.
| After any safety-related parts have been replaced (e.g. power switch or circuit
breakers) a safety check must be performed (visual inspection, protective earthing
conductor load, leakage resistance, leakage current measurement, function test).
| Heed all the other job-specific safety measures and requirements listed in the
sequences of actions.
Heed the security labelling!
In addition to the safety instructions set forth in the product documentation for the , all
the safety markings in the equipment rack must be observed. They point out potential
hazardous areas and must neither be removed nor changed.
2.3.1 Authorised personnel
The product may be transported, set up, connected, commissioned, operated and serv-
iced only by specialists who are familiar with and comply with the applicable safety reg-
ulations and setup instructions.
The specialists must be authorized to perform the required tasks by the person respon-
sible for the safety in the enterprise of the operator.
Specialists are persons, who:
| are trained and experienced in the corresponding field
| are familiar with the relevant standards, regulations, provisions and safety codes,
and
| have been instructed in the mode of operation and the operating conditions of the
equipment components
| can identify and avert hazards