User's Manual

DIB-500 R4.1 Configuration
Configuring the software
140 Installation, Operation and Service Manual 90DIB500R41IM_FCC02 – 99.1
8. Enter the following command to open the corresponding configuration file:
vi /etc/udhcpd.conf
➥ The "udhcpd.conf" configuration file is opened. The following output is an exam-
ple:
# ================================================================
# ACCESSNET-T Configuration File
#
# Network : cta
# Description : cta
# Package Version : 7.0
# Network Element : bs01-002 (DIB1_12)
# Software Component : aeos-intel_1 (AEOS Intel)
# Software Version :
# Configuration Version : 1001281502
# Generated by : NMC-515 ConfigurationManager 03.01.00
# Date/Time : 28.01.2010 15:02:32 CET
# ================================================================
start 10.101.101.49
end 10.101.101.49
interface eth1
siaddr 10.101.101.33
option lease 864000
option subnet 255.255.255.224
max_leases 1
dhcp_magkey 0x13242c8
opt bootfile autoscript.img
9. Navigate to the IP address of the "start" entry with the arrow keys.
10. Enter the following command to delete the corresponding line:
x
11. Enter the following command to insert a corresponding figure:
I
12. Enter the corresponding IP address of the PowerPC, refer to Table 6.9 on
page 138.
The IP addresses in the "start" and "end" entries must be identical. Otherwise the
proper operation of the PowerPC is not ensured.
➔ Ensure that the IP addresses in the "start" and "end" entries are identical.
13. Proceed analogously for the IP address of the "end" entry.
14. Navigate to the IP address of the "siaddr" entry with the arrow keys.
15. Enter the following command to delete the corresponding line:
x
16. Enter the following command to insert a corresponding figure:
I