User's Manual

Site Requirements 90DIB500R41SR_FCC02 – 99.1 13
DIB-500 R4.1 Safety regulations
Intended use
2.1.2 Safety instructions and declaration of conformity for North America
The product complies with the requirements of the Federal Communications Commis-
sion (FCC).
This device complies with part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions:
| This device may not cause harmful interference, and
| this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user's authority to operate the equipment.
The product complies with the requirements of Industry Canada (IC).
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appar-
eils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
| l'appareil ne doit pas produire de brouillage, et
| l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
| this device may not cause interference, and
| this device must accept any interference, including interference that may cause
undesired operation of the device.
2.2 Intended use
The product is solely intended to be used as an base station in the ACCESSNET
®
-T IP
mobile radio system. It is used in this application to transmit voice communication
between subscribers, which are equipped with an appropriate mobile.
Intended use also includes that:
| all the safety instructions set forth in the product documents are always heeded.
| all the maintenance tasks described are performed in the interval specified.
| the general, national and in-house safety regulations are heeded.
Any other use is impermissible.
The product is not used as intended, for example, if:
| the requirements described in the product documents haven not been met and
instructions are disregarded.
| the structural design of the product is modified without the consent of the Rohde &
Schwarz Professional Mobile Radio GmbH.
| replacement parts are used that differ from the components installed by default.
The operator of the product is responsible for damage to the product or damage caused
by the product if the product was used beyond the intended application range and/or
was not used as intended.