Quick Reference Guide

To receive and transmit data and voice, do as follows:
1. Select a zone in either of the following ways:
l On the Zone menu, press the Up or Down key to
select a zone, and then press the OK/Menu key.
l Press the preprogrammed Zone Up or Zone
Down key.
2. Select a channel in one of the following ways:
l Rotate the Channel Selector knob.
l Press the preprogrammed Channel Up or
Channel Down key.
l Press the preprogrammed Preset Channel key.
If the Voice Notify feature is enabled by your
dealer, the radio announces the channel number
upon channel switching.
Trunking Mode
In trunking mode, the radio communicates with each
other through base stations after successful registration.
The radio can communicate with a group of radios or a
single radio.
Selecting Subgroups
A subgroup is a group of group or private contacts. To
select a subgroup, do either of the following:
l Press the Back/Subgroup key and then press the Up
or Down key.
l Press the preprogrammed Subgroup Up or Subgroup
Down key.
Selecting Group or Private Contacts
l Rotate the Group Selector knob.
l Press the Back/Subgroup key and then press the Up
or Down key to select from the member list.
l Press the preprogrammed Group/Private Up or
Group/Private Down key.
Status Indications
Checking LCD Icons
The following tables list icons that may appear on the
radio's liquid-crystal display (LCD).
Operation Mode
Icon Radio Status
DM
Direct mode: The radio transmits and
receives directly.
RM
Repeater mode: The radio transmits and
receives through a repeater.
TM-DW
Trunking Mode - Digital Wide: The radio
operates under multiple interconnected BSs.
TM-DL
Trunking Mode - Digital Local: The radio
operates under a single BS.
DM-R
Direct mode: The single frequency repeat
(SFR) feature is enabled on the current
channel.
The Mode Automatic Switch feature is
enabled.
Basic Status
Icon Radio Status
The Dual-Tone Multi-Frequency (DTMF)
keypad is enabled.
Icon Radio Status
There is no signal in DM, RM, or TM-DW
mode.
The number of bars indicates the signal
strength in DM, RM, or TM-DW mode.
There is no signal in TM-DL mode.
The number of bars indicates the signal
strength in TM-DL mode.
The radio operates in high power mode.
The radio operates in low power mode.
An accessory is connected.
The Global Positioning System (GPS) feature
is enabled, and the radio receives GPS data.
The GPS feature is enabled, but the radio
receives no GPS data.
The radio is in emergency mode.
The radio is roaming.
The radio is detecting sites for roaming.
The Scrambler or Encrypt feature is
enabled.
The Over The Air Encrypt feature is
enabled.
The radio is scanning or hunting.
The radio stays on a non-priority channel.
4