Quick Reference Guide

l The call duration preset by your dealer expires.
l A preemptive or emergency call interrupts the call.
l The calling or called party switches to an empty
group.
l The base station signal is lost.
Analog Calls
You can initiate or receive a call on an analog channel
with or without signaling.
Call Without Signaling
On an analog channel without signaling, you can initiate a
call to all the other users on the channel. Do as follows:
1. Select the required channel.
2. Press and hold the PTT key, and speak into the
microphone.
Call With Signaling
On an analog channel with signaling, you can initiate a
call to a specific contact on the channel. Do as follows:
1. Rotate the Channel Selector knob to select the
required channel.
2. Press the OK/Menu key, and go to Contact >
Contact List.
3. Select the required channel.
4. Press the PTT key or the preprogrammed One Touch
Call/Menu key to send the code.
The call is established when the target radio receives and
decodes the matched signaling.
Emergency Call
In case of emergency, you can initiate an emergency call
to ask for help from other personnel or the control centre.
This feature needs to be configured and enabled by your
dealer. For details, refer to the Emergency feature
described in the relevant user manual.
Message Services
The Message feature allows you to send and receive the
following types of messages in trunking mode or on a
digital channel in conventional mode:
l Text messages: messages created using the keypad.
l Quick text messages: frequently used messages
predefined by your dealer but editable.
l Status messages (trunking only): frequently used
messages predefined by your dealer and not editable.
Viewing Messages
To view a message upon receiving, directly press the
OK/Menu key.
To view a message from the Inbox or a sent message, go
to Message > Inbox/Outbox, and then select the required
message.
Sending Messages
Sending Text Messages
1. Go to Message > New Msg, and then type the text.
2. Press the OK/Menu key, and then select Send.
3. Select or enter the required contact, and then press
the OK/Menu key.
Instead of directly sending the new message, you
can also select Save in conventional mode or select
Save to Drafts or Save to QuickText in trunking
mode to save the new message, and send it later.
Sending Quick Text Messages
1. Go to Message > Quick Text, and then select the
required quick text message.
2. Select Send, and then select or enter the required
contact.
3. Press the OK/Menu key.
Sending Status Messages
1. Go to Message > Status Msg, and then select the
required status message.
2. Press the OK/Menu key, and then select or enter the
required contact.
3. Press the OK/Menu key.
You can also send status messages by manual
dialing. For details, contact your dealer.
Deleting Messages
Deleting Text Messages
To delete a message from the InBox, OutBox, or Drafts,
do as follows:
1. Go to Message > InBox/OutBox/Drafts.
2. Select the required message, and then press the
OK/Menu key.
3. Select Delete, and then press the OK/Menu key.
8