User's Manual

DS-6210VC4 Base Station Owner's Manual Installation
34
Figure 3-10 Loosening the Ejector
2. Slide the BSCU along the guide rails smoothly as shown in Figure 3-11（1）.
3. Perform the step 1 in a reverse way to lock the two ejectors.
4. Tighten the two screws on the two ejectors and the board respectively as shown in Figure 3-11
（2）.
Note:
Loosen the two ejectors and draw out the module in case of removing it during installation.
Push
Figure 3-11Installing the BSCU
Step 4 Install the FAN as shown in Figure 3-12.
Slide the FAN along the guide rails smoothly until a click is heard.