Owner's Manual

LED Indication
LED Indicator Radio Status
Flashes green Being turned on.
Glows green Receiving.
Glows red Transmitting.
Flashes orange slowly Scanning.
Glows orange
Call hang time: No voice is being transmitted or
received on the channel during a call. Within such
a period, you can hold down the PTT key to speak.
Before Use
Attaching the Antenna
Do not hold the radio by its antenna, as it may reduce the radio
performance and life span of the antenna.
1. Place the antenna in its receptacle.
2. Rotate the antenna clockwise.
Attaching the Battery
1. Insert the top end of the battery into the top of the battery slot.
2. Press the bottom end of the battery until the latch snaps into place.
To remove the battery, make sure that the radio is turned off, and
then slide the battery latch upwards to unlock the battery.
Attaching the Belt Clip
1. Unfasten the two screws on the back of the radio.
2. Align the screw holes on the belt clip with those on the back of the radio.
3. Tighten the screws.
Attaching the Accessories
1. Loosen the screw on the accessory connector cover, and then open the
cover.
2. Plug the accessory into the accessory connector.
3. Tighten the screw on the accessory plug.
Charging the Battery
Use the charger specified by the Company to charge the battery.
Be sure to charge the battery fully before initial use, since reduction of state
of charge (SoC) may lead to low battery alarm. You can charge the
standalone battery or the radio with battery attached. It is recommended that
your radio remain powered off during charging.
4