User's Manual

HYPRO WATER – 09.2020
28
If the fault persists:
y Turn the shut-off valve in the “CLOSE”
direction with the water tap open.
➡ “3.4 / 19” (page19).
y Turn the shut-off valve in the “OPEN”
direction with the water tap open.
➡ “3.5 / 3” (page21).
Quantity drawn off <3l/min
– Take-off quantity varies depending on
the type of filter used.
– Line pressure insufficient.
y Contact your installation engineer.
– Filter capacity depleted.
y Change the filter.
➡ “6.1 Changing the filter”
(page25).
Water escaping at the device.
– Hose connections have not been
correctly established.
y Check the hose connections and safety
clips.
– Screw-on cover to the filter chamber
not closed properly.
y Make sure the screw-on cover to the
filter chamber is screwed to the stop.
If the fault persists:
y Close the angle valve on the cold water
line.
y Contact your installation engineer.
The screw cap for the filter chamber does
not release.
– The pressure in the device has not
been relieved.
y Relieve the pressure in the device.
Turn the shut-off valve in the “CLOSE”
direction.
➡ “3.4 / 19” (page19).
y Open the drinking water tap until no
further water runs out of the water tap.
y Close the drinking water tap again to
prevent a backflow of water.
If it is not possible to remedy a fault:
y Contact customer service.