User's Manual

11
HYPRO WATER – 09.2020
11
3. Assembly
3.1 Requirements applicable to the
installation site
– The installation site must be clean and
dry.
– A suitable socket must be available at
the installation site. The socket must be
set up by a qualified electrician. The
power connections must comply with
the local regulations. The mains power
supply must concur with the voltage
specifications on the type plate.
➡ “2.4 Technical data” (page10).
– For assembly above the worktop, a
suitable cut-out must be available in or
behind the worktop through which the
mains cable and hoses are fed.
– If the wall bracket is used: Select the
installation site such that 10cm remain
clear below the device to enable
mounting on the wall bracket.
– Select the installation site such that
20cm remain clear above the device
to enable the filter change.
– If the device is used with the HYPRO
app: A WLAN connection to the
internet must be available at the
installation site.
– A 3-way water tap or an additional
water tap must be installed at the
installation site.
Examples:
3.1 / 1
y Observe the documentation for your
water tap.
 Documentation for the water tap.