Installation Manual

CABLE REMOVED WHILE PROGRAMMING

The programmer will lose power during programming if

the cable is removed for any reason. If this happens, simply

reconnect the cable. The programmer will identify the vehicle

and then display these screens:

The programmer will then continue programming from where

it was interrupted.

ATTEMPTING TO PROGRAM A DIFFERENT VEHICLE

If attempting to program the computer in another vehicle

without first programming the original vehicle back to stock,

the following screen will appear:

CALIBRATION NOT FOUND

If the vehicle has a factory program that is not recognized by

the programmer, it cannot continue. This screen will appear:

Call the tech service line that appears on the programmer screen.

Please have the vehicle VIN number ready.

ROGRAMMING WAS

INTERRUPTED...

PROGRAMMING WILL

CONTINUE NOW

CODE 91: PROGRAM YOUR VEHICLE BACK TO STOCK BEFORE

PROGRAMMING ANOTHER VEHICLE

CODE 6D:

CAL NOT FOUND

If the programmer was interrupted during the Reading stage,

programming will NOT be considered interrupted, and the

programmer will proceed to Section 1 on page 3.

IMPORTANT NOTE