Installation Manual

10
REPORT
This screen will now show all the selections that have been made:
Watch the selections scroll by on the screen. If all the selections
are correct, press ‘Y’ to start programming the vehicle. If changes
need to be made to any of the selection(s), press the ‘N’ button
to start over from the beginning.
PROGRAMMING
Follow all of the prompts on the programmer screen during the
entire programming process for the vehicle.
While the unit is
programming, the following is EXTREMELY IMPORTANT:
DO NOT leave the vehicle while programming is in process.
DO NOT unplug or disturb the cable, turn the key off, or
start the engine (unless instructed to by the programmer).
If the unit stops programming or is interrupted, please
make a note of any message(s)
that appear on the
programmer screen
and call the provided tech service line.
After the programmer has successfully programmed the vehicle,
wait thirty (30) seconds, then unplug the programmer from the
vehicle and start the engine, making sure the “Check Engine”
light on the instrument cluster goes out (If it stays on or flashes,
call the provided phone number). Warm up the engine and make
sure it is running smoothly.
FOR ONSTAR or SATELLITE RADIO EQUIPPED VEHICLES.
Plug any connector(s) back into the original location and reinstall
any panels and/or other interior components that were removed
prior to programming
.
YOU HAVE CHOSEN
..........
On certain applications, the dash message center may display
random code information such as REDUCED ENGINE
POWER. This is a NORMAL step during the programming
process for certain applications.
IMPORTANT NOTE