Safety Data Sheet

Shenzhen Anbotek Compliance Laboratory Limited
Page
7
of
8
Report No. R0117040175B
This Test Report is issued by the Company subject to its General Conditions of Service printed overleaf. Attention is drawn to the limitations
of liability, indemnification and jurisdictional issues defined therein. The results shown in this report refer only to the sample(s) tested unless
otherwise stated. This Test Report cannot be reproduced, except in full, without prior written permission of the company.
Shenzhen Anbotek Compliance Laboratory Limited
Address: East of 4/F., Building A, Hourui No.3 Industrial Zone, Xixiang Street, Bao'an District, Shenzhen, Guangdong, China
Tel: [phone] Fax: [phone] Email: [e-mail] Http: //www.anbotek.com.cn
Section 13. Disposal Considerations
1. Disposal of the battery should be performed by permitted, professional disposal firms
knowledgeable in Federal, State or Local requirements of hazardous waste treatment and
hazardous waste transportation.
2. The battery should be completely discharged prior to disposal and/or the terminals taped or
capped to prevent short circuit. When completely discharged it is not considered
hazardous.
3. The battery contains recyclable materials. Recycling options available in your local area
should be considered when disposing of this product, through licensed waste carrier.
Section 14. Transport Information
According to PACKING INSTRUCTI ON 965 ~ 967 of I ATA DGR 58th Edition for
transportation, the special provision 188 of IMDG (inc Amdt 38- 16). The batteries should be
securely packed and protected against short-circuits . Examine whet he r the package of the
containers are integrate and tighten closed before transport. Take in a cargo of them without
falling, dropping, and breakage. Prevent collapse of cargo piles. Don’ t put the goods toge the r
with oxidizer and chief food chemicals. The transpor t vehicle and ship should be cleaned and
sterilized before transport . Dur ing transport, the vehicle should prevent exposure, rain and
high temper ature . For stopovers, the vehic le should be away from fire and heat sources. When
transported by sea, the assemble place should keep away from bedroom and kitchen, and
isolated from the engine room, power and fire source. Under the conditi on of Road
Transportation, the driver should drive in accordance with regulated r oute, don’t stop over in
the resident ial area and congested area.
(a) UN number
3480&3481
(b) UN Proper shipping name
LITHIUM I ON BATTERIES (including lithium ion polymer batter ies) or; LITH IUM ION
BATTERIES CONTAINED I N EQUIPMENT or LITHIUM ION BATTERIES PACKED
WITH EQUIPMENT (including lithium ion polymer batteries)
(c) Transport hazard class(es)
9
(d) Packing Instruction (if applicable)
965 II/ IB, 966 II, 967 II