Safety Data Sheet

Shenzhen Anbotek Compliance Laboratory Limited
Page
6
of
8
Report No. R0117040175B
This Test Report is issued by the Company subject to its General Conditions of Service printed overleaf. Attention is drawn to the limitations
of liability, indemnification and jurisdictional issues defined therein. The results shown in this report refer only to the sample(s) tested unless
otherwise stated. This Test Report cannot be reproduced, except in full, without prior written permission of the company.
Shenzhen Anbotek Compliance Laboratory Limited
Address: East of 4/F., Building A, Hourui No.3 Industrial Zone, Xixiang Street, Bao'an District, Shenzhen, Guangdong, China
Tel: [phone] Fax: [phone] Email: [e-mail] Http: //www.anbotek.com.cn
Boiling point: N/A
Solubility in water: Insoluble
Specific gravity: N/A
Density: N/A
Section 10. Stability and Reactivity
Stability: Stable
Conditions to Avoid: Do not heat, throw into fire, disassemble, short circuit, immerse in
water or overcharge, etc.
Incompatibility: None during normal operation. Avoid exposure heat, open flame and corrosives.
Hazardous Polymerization: Will not occur.
Hazardous Decomposition Products: The battery may release irritative gas once the
electrolyte leakage.
Section 11. Toxicological Information
The battery does not elicit toxicological properties during routine handling and use. If the
battery is opened through misuse or damage, discard immediately. Internal components of
cell are irritant and sensitization.
Irritancy: The electrolytes c ontained in this battery can irritate eyes with any contact.
Prolonged contact with the skin or mucous membranes may cause irritation.
Sensitization: No information is available.
Teratogenicity: No information is available.
Carcinogenicity: No information is available.
Mutagenicity: No information is available.
Reproductive toxicity: No information is a vailable.
Section 12. Ecological Information
1. When properly used and disposed, the battery does not present environmental hazard.
2. The battery does not contain mercury, cadmium, or lead.
3. Do not let internal components enter marine environment. Avoid releasing to water ways,
wastewater or ground water.